River Rouge and the Downriver corridor along the Detroit River is one of the most demanding roofing environments in the state. Steel, chemical, marine terminal, power generation and heavy process facilities sit within a mile of each other, and their roofs take airborne particulate, chemical fallout, salt, vibration and constant maintenance traffic. A residential-grade system does not survive here. Ours are specified for the exposure.
Specifying for a Heavy Industrial Roof
- Chemical and particulate exposure. Coating chemistry chosen for what is actually landing on the roof, not for the lowest bid per square.
- Traffic. Granulated walkways and reinforced service paths where crews access rooftop equipment daily.
- Vibration and movement. Seamless fluid-applied systems tolerate deck movement far better than mechanically fastened membranes.
- Penetration density. Process piping, stacks, ductwork and conduit — all self-flashed by the foam rather than hand-detailed.
- Operational continuity. No tear-off means no exposed deck over live process equipment.
One Contractor for the Roof and the Containment
Spray polyurethane foam roofing and polyurea protective coatings come out of the same family of chemistry and the same rigs. That means a facility can address the roof, the secondary containment berms, the tank exteriors, the process floors and the trench and sump work under one contractor and one specification.
For a Downriver plant, that is not a convenience argument — it is a shutdown-window argument. Fewer mobilizations, fewer contractors on site, fewer permits.
- SPF roof systems over existing built-up and single-ply
- Secondary containment coatings for berms and dikes
- Industrial polyurea for floors, trenches and sumps
- Storage tank insulation and coatings
- Polyurea waterproofing for structures and decks
Downriver Coverage
River Rouge, Ecorse, Melvindale, Dearborn, Lincoln Park, Wyandotte, Southgate, Allen Park, Taylor and the Detroit industrial riverfront. See also our Detroit flat roofing page and the full Michigan service area list.
Industrial Roofing FAQs
Do your roof systems hold up in a heavy industrial environment?
That is what they are built for. Downriver roofs deal with airborne particulate, chemical exposure, salt, constant vibration and heavy service traffic. We specify coating chemistry to match the exposure — urethane topcoats where abrasion and impact are the issue, silicone where ponding and UV dominate — and we granulate traffic paths so maintenance crews are not walking on bare coating.
Can you also do containment and floor coatings while you are on site?
Yes. Polyurea is the same family of chemistry and we apply it to secondary containment berms, tank exteriors, process floors, trenches and loading areas. Doing the roof and the containment work under one contractor saves mobilization and keeps the specification consistent. See our secondary containment coatings and industrial polyurea pages.
How do you handle safety requirements on an industrial site?
We work to the site's requirements — orientation, permits, hot work procedures, lockout where required, and confined space protocols where they apply. Our crews are used to plant environments rather than residential job sites.