Direct: (810) 366-0568 Office: (810) 545-0074
Mon to Fri: 7am to 5pm Sales Available 24/7

Metal Roof Coatings & Restoration

Stop Fastener Leaks and Rust Without Replacing Panels. Commercial, Agricultural & Industrial Roofs

A metal roof rarely fails all at once. It leaks at the screws, then at the end laps, then rust starts creeping out from the seams and around the skylights. SprayTight restores metal roofs on warehouses, manufacturing plants, shops, pole barns and agricultural buildings across Michigan: we treat the rust, seal every fastener and seam, and spray a seamless coating over the whole roof so it stops leaking without replacing a single panel.

Why Metal Roofs Leak

Metal moves. A roof panel heats up in July sun and shrinks on a January night, and every one of those cycles works the fasteners loose. The rubber washers under the screw heads dry out and crack, and every backed-out screw becomes a pinhole. Add rust at the laps, failed sealant at ridge caps and skylights, and gutters that hold water against the panel edges, and a roof that looks fine from the parking lot is leaking in a hundred small places.

Chasing those leaks one screw at a time is a losing game. A coating system fixes every fastener, seam and lap at once, then protects the metal so the rust stops spreading.

Metal roof restoration with spray foam and coating over corrugated panels in Waterford Michigan

Our Metal Roof Restoration Process

  1. Assessment. We walk the roof, check panel condition, look for rust-through and soft decking, and document every problem area with photos.
  2. Cleaning. The roof is pressure washed to remove dirt, chalking and loose rust so the coating can bond.
  3. Rust treatment. Rusted areas are treated and primed. Panels that have rusted through are patched or replaced before anything else happens.
  4. Fasteners. Backed-out and stripped screws are tightened or replaced with oversized fasteners.
  5. Seams and details. Every fastener, end lap, side lap, ridge cap, skylight and penetration is sealed with a reinforced detail coat.
  6. Coating. A base coat and topcoat of silicone or urethane go over the entire roof, creating one continuous, reflective membrane.

Most metal roofs are coated in a few days, with no tear-off, no dumpsters and no shutdown of the business or operation underneath.

Coating or Spray Foam Over Metal?

A coating alone is the right answer when the building is unheated or already insulated and the problem is leaks and rust. When the building is also hot in summer, cold in winter or dripping condensation from the underside of the panels, spraying SPF roofing foam over the metal before coating adds insulation, buries every fastener and seam under a continuous layer, and smooths out the corrugations. For condensation problems you can also insulate from the inside with metal building spray foam insulation. We will tell you which one your building needs.

Metal Roof Coating Cost

OptionWhat it includesTypical installed cost
Metal roof coating systemCleaning, rust treatment, fastener and seam sealing, silicone or urethane base and topcoat$3 to $6 per sq ft
Spray foam plus coating over metalInsulating foam layer over the panels, finished with a protective coating$6 to $9 per sq ft
Panel replacementTear-off and new metal panels$8 to $15+ per sq ft

Where your roof lands in those ranges depends on how much rust treatment and fastener work it needs, the number of skylights and penetrations, building height and total size. Large roofs cost less per square foot because mobilization is a fixed cost. The full breakdown is in our roof coating cost per square foot guide.

Buildings We Coat

Warehouses & Distribution

Large, simple roofs where coating economics are at their best.

Manufacturing & Plants

Low odor, low noise application while production keeps running.

Pole Barns & Ag Buildings

Stop the leaks and rust on barns, equipment storage and pole barns.

Retail & Self-Storage

Long runs of metal roofing restored without disturbing tenants.

Churches & Schools

Restoration that fits a facilities budget better than replacement.

Municipal & Utility

Garages, salt barns, maintenance facilities and utility buildings.

Where We Coat Metal Roofs

We coat metal roofs across Michigan from our base in Columbiaville, including Warren, Sterling Heights, Pontiac, Troy, Detroit, Clawson, Canton, Brighton, Flint, Lapeer, Lansing, Eaton Rapids, Albion, Holland and Dowagiac, plus farm and industrial buildings throughout the Thumb and mid-Michigan. For large commercial and industrial roofs our coating crews travel nationwide. See the full service area.

Metal Roof Coating Questions

Will a coating stop the rust on my metal roof?

Yes, when the rust is treated first. Surface rust is cleaned and primed so it stops spreading, and the coating seals the metal away from water and oxygen. Panels that have rusted all the way through get patched or replaced before coating, because no coating can bridge a hole in the metal.

Do the screws have to be replaced before coating?

Not all of them. We tighten fasteners that have backed out and replace stripped or missing ones with oversized screws. Then every fastener head is sealed with a detail coat before the full coating goes on, which is what finally stops the leak at every screw.

Silicone or acrylic for a metal roof?

It depends on the roof. Silicone handles ponding water and weathering well and is our most common choice on low-slope metal. Urethane is tougher where there is foot traffic. Acrylic can work on steeper roofs where water never sits. Our silicone vs. acrylic vs. urethane comparison explains how we choose.

Can you coat a pole barn or agricultural roof?

Yes. Pole barns, equipment buildings and farm shops are some of the most common metal roofs we restore. If the building is also used as a heated shop, ask about foam: insulating while you seal the roof often costs less than doing the two jobs separately.

How long does a metal roof coating last?

The coating is designed to be renewed rather than replaced. When the topcoat weathers, typically after 10 to 15 years, the roof is cleaned and recoated at a fraction of the original cost, and the metal underneath stays protected.

Get a Free Metal Roof Assessment

We will walk the roof, document the rust and leaks, and give you a firm price for coating it, plus the foam option if your building would benefit from insulation. Office: (810) 545-0074.

Get Project Pricing (810) 366-0568
2026 Commercial Roof Cost Estimator

Estimate Your Roof Coating vs. Tear-Off Cost

Select your existing commercial roof type and slide your approximate roof square footage to compare 2026 installed restoration pricing against full tear-off replacement.

1,500 sq ft25,000 sq ft100,000 sq ft
Estimated SprayTight Restoration
$30,000 – $60,000
vs. Tear-Off & Replace: $85,000 – $150,000+
Estimated Capital Savings: ~$55,000 – $90,000
Lock In Free On-Site Roof Assessment
Or call 24/7 commercial sales: (810) 366-0568
Fast Same-Day / Next-Day Pricing

Get Free Project Pricing

Tell us your Michigan city (or commercial job state) and approximate square footage — Eric Qualls & the SprayTight estimating team reply within 1 business day.

  • 25+ Years & 1,000,000+ Sq Ft Sprayed Since 1996
  • 4.9★ Google Rating (96 Reviews) • SPFA Member
  • 10% Military Veteran Discount
Call Now Get Pricing